All equipment listed is subject to availability and prices are subject to change without notice

Improving Safety and Cutting Costs with the Right Pipe Alignment Clamps

Written by blogadmin on June 27, 2014. Posted in Uncategorized

1

Improving Safety and Cutting Costs with the Right Pipe Alignment Clamps

While this might be the most obvious reason, it is not the only one. Cutting down on labor costs while improving safety are two other major reasons why using the right clamps is so important.

There are quite a few reasons why it is best to buy top quality pipe alignment clamps and then weld them into place. Of course, the obvious reason why these clamps are so necessary is they hold the weld joint in place so the proper welding job can be done.

If the clamps do not do their primary job of holding pipes in place, then the pipes are going to come loose or become outright detached. Once this occurs, then the previously performed work has to be done again.

In other words, the same job has to be done twice.

The sentiment that it is worth doing a job again and again until it is done right is fine as long as repeating the job is unavoidable. If workers are required to remove clamps, replace them, and then weld them into place a second time, this all comes with costs. Labor, materials, and supplies are all expensive. Doing the job once cuts down the costs immensely.

Safety issues are going to arise when the clamps put on the pipes are not able to remain in place. Any supplies that are faulty come with risks. Qualty materials that do not falter are going to improve safety because they do not create any hazards.

For these reasons alone, consider is wise to purchase solid pipe alignment clamps produced by equally high quality, reputable manufacturers.

Screen shot 2013-06-11 at 3.51.03 PM Screen shot 2013-06-11 at 3.51.14 PM
Screen shot 2013-06-11 at 3.51.08 PM