PDF – Sulliar 900xh Portable Air Compressor

PORTABLE AIR COMPRESSOR
900 CFM AT 350 PSIG—425 L/S AT 24 BAR 
ROTARY SCREW COMPRESSOR
0 TO 100% CAPACITY CONTROL
ELECTRONIC ENGINE CONTROL
IDLE WARM-UP VALVE
CURBSIDE INSTRUMENT PANEL–
MECHANICAL GAUGES
DIAGNOSTIC SHUTDOWN INDICATORS
CIRCUIT BREAKER
ENGINE MONITOR SYSTEM
HIGH/LOW PRESSURE SELECTOR VALVE
PROTECTIVE SHUTDOWN SWITCHES
TWO-STAGE AIR FILTERS WITH
SAFETY ELEMENT
AMPLE SERVICE DOORS
SWING-DOWN COOLER
THREE MOUNTING OPTIONS–
LESS RUNNING GEAR
FOUR-WHEEL STEERABLE
TRI-AXLE–
SURGE HYDRAULIC BRAKES
MECHANICAL PARKING BRAKE
E-Z LUBE AXLE
AWF COMPRESSOR FLUID

Challenger offers cold cutting machines for your pipes.  The rugged and powerful CGM-1 Pipe Cold Cutting and Bevel Machine cuts and bevels pipes or shells ranging from 6 to 72 inches (152 – 1826mm) in diameter with a wall thickness of ¼” to 2 5/16” (6 – 60mm) . The CGM-1, available in pneumatic and hydraulic models, can produce almost any type of pipe end configuration imaginable including standard bevels, “J” preps and lands by simply changing the cutting and beveling blades. The machines will cut and bevel any machinable material such as carbon steel, stainless steel, ductile iron, cast iron, and most other alloys without spark or flame. A second cut is not required as the machine bevels both sides of the cut simultaneously.

Need a clamshell bucket?  Download our spec sheet below.

PDF – Clamshell Bucket

Specifications 
Material Density  Max 2.6 t/m3
Lifting Capacity:  Max 6.5 t
Torque/100 bar:  1200 Nm
Rotary Head:      Hydraulically rotates 360°

General Data
Operating Pressure: Rotating—Max. 200 bar, Opening/Closing—Max. 300 bar

PDF – PC 350 Portable Air Compressor

For operating pneumatic pipe bending mandrels and internal line up clamps.