All equipment listed is subject to availability and prices are subject to change without notice

Pipe Bending Sets

Written by cefar on June 11, 2013. Posted in Bending Machines, Bending Sets, Mandrels and Clamps

pipe bending sets

 

PDF – Pipe Bending Set

CHALLENGER PIPE BENDING SETS

Our pipe bending sets are built to last.  For Hydraulic Pipe Bending Machines 6-20, 16-30, 22-36, 32-42, 48-60

Full bending sets, dies (only), and liner sets are available for use with all standard bending
machines, for pipe diameters from 4 inches to 60 inches.  Bending sets and dies are available bare
or with linings, to correspond to the coating on the pipe (see bending set recommendations below).
Liners can be supplied as spray, poured or strip urethane, copper, brass or stainless steel.

A separate bending set (or die only for the maximum diameter the bending machine will accept) is
required for each diameter of pipe.

Standard bending sets will accommodate pipe manufactured to API-5L standards.  Special order
bending sets and dies are available for non-standard diameters and/or pipe coatings.

Trackback from your site.

Screen shot 2013-06-11 at 3.51.03 PM Screen shot 2013-06-11 at 3.51.14 PM Screen shot 2013-06-11 at 3.51.08 PM